IRP1-STF02 Rear Expansion Extra Long M4 x 16 screw and hex nuts kit
for IRP208DB and ERP100DB DIN Rail Panel
ONLINE ORDER
| Model # | Description | Price | Add to Cart |
|---|---|---|---|
| IRP1-STF02 | Rear Expansion extra long (10) M4x16 screws and (10) Hex nuts kit | $12.00 | BUY |
Features
- Enables rear-side mounting of DIN rails on DIN Rail Panels
- Extra long M4 screws and Extra heavy fender washers.
- Supports up to (3) DIN rail or PVC wire duct per kit
- Compatible with RCB series, IRP208DB, and ERP100DB DIN Rail Panels
- Comes with (10) M4 x 16 mm Truss Screws, (10) 15mm Fender washer, (10) M4 K-Hext Nuts and (10) Extra Heavy Feder washer.
Overview
How to install IRP1-STF02 Rear Expansion Standoff Kit ?
The IRP1-STF02 can only be installed using existing M4 PEM nuts on the DIN Rail. If a DIN Rail is already installed at the desired M4 PEM nut position, first remove the existing M4 x 8 screw. Then, replace it with a longer M4 x 16 screw. Once the M4 x 16 screw is in place, insert the extra-thick fender washer onto the screw. Position the DIN Rail on top of the fender washer, and then place a 15mm fender washer over the DIN Rail. Finally, secure the assembly by tightening the M4 screw with M4 hex nuts.
When to use the IRP1-STF02 Rear Expansion Standoff Kit
In situations where the rear side of a DIN Rail panel is needed to install an additional DIN Rail or PVC wire duct, and the panel does not support IRP1-CBN rear mount expansion brackets, the IRP1-STF02 standoff kit is required. The IRP1-STF02 utilizes the existing M4 PEM nuts in the DIN Rail panel to install a longer M4 x 16mm Truss screw . This allows additoinal DIN rail to be install on rear side. .
Difference Between IRP1-CNB and IRP1-STF02
The IRP1-CNB is a specialized bracket for mounting on the rear side of the DIN Rail panel without interfering with the front-side installation. It allows more flexible positioning of DIN Rails or PVC ducts at any rear-side location. In contrast, the IRP1-STF02’s mounting position depends on the existing M4 PEM nuts . You can only mount DIN Rail or PVC wire duct at the position with existing M4 PEM nuts.
Difference Between IRP1-STF01 and IRP1-STF02
While both offer similar functionality, the IRP1-STF02 relies on the existing M4 PEM nuts on the DIN Rail panel for mounting, using longer M4 screws. Unlike the IRP1-STF01, it cannot be installed directly into the 9x9 square holes, limiting its mounting positions to where M4 PEM nuts are available.
Specification
| Model | IRP1-STF02 |
|---|---|
| Screw Size | M4x16 |
| Screw Head Type | Trus |
| Phillips Driver Size | 2 |
| Material | ANIS 1006-1002 or equivalent steel |
| Hardness | Rockwell B70-B100 |
| Mounting Hardware Included | (10) M4 x 16 screws, (10) 15 mm Fender Washer, (10) M4 K-Hex Nuts and (10) Extra Heavy Feder Washer |
| Country of Origin | TAIWAN |
| Warranty | Limited 1 year warranty. |